小直径棒材超声横波检测仿真分析

采用超声水浸聚焦斜入射方式进行小棒材表面、近表缺陷检测时,声波在水/棒和棒/缺陷界面会发生反射、折射、散射、衍射及波形转换等一系列物理变换。此时缺陷可检性对声波入射条件十分敏感,常出现由于检测条件设置不当而导致缺陷漏检、误检的情况。为解决这一问题,本文针对小棒材超声斜入射检测中的主要参数——入射角和水距,开展声场及缺陷声响应仿真,研究检测参数对不同部位缺陷检测能力的影响,并对仿真结果进行试验验证。通过研究得到了检测水距、入射角度对缺陷检测能力的影响,并得到最优检测条件。试验验证结果表明研究制定的检测方案可有效检测出表面、近表面裂纹缺陷。     

单颗金刚石切削无氧铜的声发射关联维特征*

声发射技术可以实现无氧铜切削加工特征的监测与评价。采用声发射技术监测单颗金刚石磨粒旋转切削无氧铜，利用G-P算法重构出声发射时域信号相空间，采用自相关函数法计算出相空间时间延迟参数，通过相空间双对数曲线的计算，得到不同切削工况下的关联维数。研究结果表明，进给速度和切削速度对声发射信号影响较不显著，切深与声发射信号振幅呈正效应关系；声发射信号双对数曲线呈现阶段性增加趋势，并逐渐收敛于饱和状态，关联维数随着嵌入维数的增加先快速下降后趋于平稳；金刚石切削无氧铜的声发射信号具有混沌运动变化特性，在较小嵌入维数时，关联维数与切深和切削速度呈现线性负效应关系，与进给速度呈现线性正效应关系。该研究为无氧铜的切削加工提供理论参考。     

Ultrasensitive determination of mercury by solution anode glow discharge atomic emission spectrometry coupled with hydride generation

An innovative method for the ultrasensitive detection of mercury by solution anode glow discharge atomic emission spectroscopy (SAGD-AES) coupled with hydride generation (HG) was first investigated. In this method, the mercury vapor generated by the HG was transmitted to the SAGD through the miniature hollow tungsten tube for excitation and detected by a miniaturized spectrograph. A thorough parametric evaluation of the HG and SAGD system was performed, including the type and concentration of carrier acid, He flow rate, concentrations of NaBH₄, discharge current and discharge gap. Under optimal operating conditions, the detection limit for Hg²⁺ achieved 0.03 μg/L, with a relative standard deviation of 1.1% at the Hg²⁺ concentration of 5 μg/L. Moreover, the correlation coefficient of the calibration curve was 0.9996 in the range between 0.1 and 10 μg/L. The accuracy and practicability of HG-SAGD-AES were verified by measuring GBW09101b (human hair), GBW10029 (fish), soil and rice samples. The results showed good agreement with the certified values and values from direct mercury analyzer (DMA).     

An experimental method for eliminating effect of rigid out-of-plane motion on 2D-DIC

The out-of-plane motion is one of the most important factors that affect the precision of two-dimensional digital image correlation (2D-DIC). In this paper, a novel solution is presented to improve conventional 2D-DIC by eliminating the effect of out-of-plane motion, including translation and rotation. Firstly, an experimental technique using two projected laser strips is proposed to measure the out-of-plane motion of a planar specimen. A theoretical model is then established to predict the pseudostrains caused by out-of-plane motion based on the pin-hole imaging model. Using the measured out-of-plane displacement, the captured deformed images used in 2D-DIC are amended to eliminate the effect of out-of-plane motion by the theoretical model. Finally, two experiments were conducted to validate the effectiveness of the proposed method. Results indicate that application of the proposed method can effectively eliminate the errors caused by out-of-plane motion.     

Lanthanum trilactate: Vibrational spectroscopic study − infrared/Raman spectroscopy

In this study lanthanum trilactate was prepared by neutralization reaction of lactic acid and lanthanum oxide, purified and identified by X-ray powder diffraction. Infrared spectra (Mid-IR region 4000–650 cm⁻¹) and Raman spectra (Stokes region 4000–100 cm⁻¹) of the high quality crystalline samples have been recorded and presented for the first time. For comparison DFT calculations were performed using Gaussian 09 D.01 and agreement between predicted and measured spectral data has been achieved. Acquired information can be utilized for substance identification for example in various industrial applications or in biological systems.     

(3S,4S)-4-氨基-3-羟基-6-甲基庚酸的合成

价廉易得的L-亮氨酸先以苄基同时保护氨基及羧基得(S)-2-(二苄胺基)-4-甲基戊酸苄酯,进而在碱性条件下与乙腈发生亲核取代反应得(S)-4-(二苄胺基)-6-甲基-3-氧代庚腈,再经硼氢化钠选择性还原羰基得(3S,4S)-4-(二苄胺基)-3-羟基-6-甲基庚腈,用双氧水氧化得(3S,4S)-4-(二苄胺基)-3-羟基-6-甲基庚酸,最后在Pd(OH)2/C-H2作用下脱掉苄基得到(3S,4S)-4-氨基-3-羟基-6-甲基庚酸,即(3S,4S)-statine。整个合成路线总产率为33.6%。     

Optical analysis of polymer powder materials for Selective Laser Sintering

This study increases the basic understanding of optical material properties of polymer powders used in selective laser sintering (SLS). Therefore, different polymer powder materials were analyzed regarding their optical material properties with an integration spheres measurement setup. By the measurements a direct connection between the absorption behavior of the solid material and the overall optical material characteristics of the same material in powdery form could be shown. The results were used to develop an advanced explanation model for the optical material properties of powders. At present, existing explanation models only consider the occurring of multiple reflections in the gaps between the particles to explain the overall optical material properties of powder materials. Thus, by also considering the absorption behavior of the single particles, the basic understanding of the beam-matter interaction and their effect on the optical material properties of powder materials can be expanded.     

Temperature and pH dual‐sensitive polyaspartamide derivatives for antitumor drug delivery

The pH‐sensitive tertiary amino groups were introduced to synthesize temperature and pH dual‐sensitive degradable polyaspartamide derivatives (phe/DEAE‐g‐PHPA) containing pendant aromatic structures and ionizable tertiary amino groups. The thermo/pH‐responsive behavior of phe/DEAE‐g‐PHPA polymer can be tuned by adjusting the graft copolymer composition. Due to the pH sensitivity of the phe/DEAE‐g‐PHPA‐g‐mPEG polymer with hydrophilic long PEG chain, the micelles and the anticancer drug‐loaded micelles were prepared by a quick pH‐changing method without using toxic organic solvent. The obtained polymeric micelles, paclitaxel‐loaded micelles and doxorubicin‐loaded micelles were stable under physiological conditions. Both the drug‐loaded micelles showed much faster release at pH 5 than at pH 7.4. The doxorubicin‐loaded micelles showed obvious and better anticancer activity against both HepG2 and HeLa cells than free doxorubicin. Thus these nontoxic, dual thermo‐ and pH‐sensitive phe/DEAE‐g‐PHPA‐g‐mPEG micelles may be a promising anticancer drug delivery system. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2016 , 54, 879–888